The Model HP 600 Hole Punch

The Hole Punch has been specifically designed for backing boards as applied to a hanging pack format. The unit will accommodate widths up to 6-.25" wide and board thickness up to 0.100". The unit is controlled electronically and operates in a self-timing mode. Photoelectric cells and pneumatic cylinders provide for simple and accurate operation.

Specifications

• Minimum width: 3.75" / 95 mm
• Maximum width: 6.25" / 159 mm
• Maximum board thickness: 0.100" / 2.5 mm
• Maximum height package: 1" / 25 mm
• Air pressure required: 90 lbs. at 2 cu. ft./min.
• Speed: up to 75 holes/minute on a 6" long board
• Voltage:
  • 110 volt/60 Hz
  • 220 volt/50 Hz
• Precision die with dual guide posts for long life and no binding.

< back >